![]() I have flown this altimeter lots of times and own several. ![]() ![]() ![]() EasyMini is hard-wired to use a 50 millisecond pyro on time, which is way more than enough for a typical low-current e-match. Because the firmware is open source, you could in theory change this and re-flash the board, but neither Apogee nor Altus Metrum provides any support in the default firmware for changing the pyro on time on EasyMini. How long is the pulse of electrical current to the igniter?Ī. If you have AltosUI installed on the laptop, that should end with Windows reporting that the device is functioning correctly.įinally, you may need to upgrade your Java version on the laptop we've had several reports that this helps make things work. You'll also be able to tell as Windows will report that it has found a new device and attempt to locate the device drivers. When ready for flight in 'pad' mode, it will beep out the igniter continuity signal once every five seconds. You can tell if this is working as it will only report the igniter continuity once and then fall silent. You need to connect the USB cable to EasyMini before powering it up so that it will start in 'idle' mode and be ready to communicate with the laptop. When I plug in my EasyMini altimiter to my laptop using a micro usb, the altos is not detecting the device.
0 Comments
Leave a Reply. |